R4512 or R4520 Ridgid Table saw. INCLUDES the front and back rails and mounting hardware.. The rip fence is NOT included. For even more table saw parts!
Delta Rockwell 37″ Long Jet Lock Table Saw Fence Rails 2pc Set 1-3/8″ Diameter. Mount holes from left to right are approximately 1-3/8″ OC, 9″ OC, 25-1/16″ OC, 32-11/16″ OC. Modified length to 37 total. Includes 2 washers, 2 nuts, 4 bolts, 4 spacers. Dirty, dusty, rusty, etc. Shows normal signs of wear.
Set of rip fence guide rails from a Ridgid ts3650 table saw, these came off of a saw that was the floor model in the store, they do have some scratches and some light marks in spots. The front rail is approximately 62 inches long and the back rail is 53 inches long. Mounting hardware is included. There are some light rust stains on the surfaces that mount against the cast iron table. Please look at all the pictures closely before purchasing and ask any questions you may have before purchasing.
Delta Table Saw 34-670 Rip Fence & Square Rails w/pins 22 1/4 top EXCEPTIONAL. These Rip Fence Rails are in EXCEPTIONAL CONDITION and is completely rust free. The ruler is excellent.
Grizzly Table Saw G1022 Rip Fence Guide Rails w/spcl bolts also Delta Contractor. The rail diameter is 1 3/8 diameter. The length is 44 1/4 long. The spacing of the mounting holes is 7 1/2 at each end (4 holes per rail). Rails are very straight. The rear rail had considerable surface rust which was wire brushed. Some minor pitting is evident on the rear rail, please see photos. The front rail had minor surface rust also which was wire brushed. Both were treated with WD-40. The rack gearing in the front rail is in very good condition. One of the 4 plastic end caps is missing.
Delta Table Saw 34-670 Rip Fence 22 1/4 top for 1 1/16 Dia rails Nice OEM Cond. This may fit the 36-600 and TS300, further research may be needed to confirm this. Very Nice OEM Condition. Clamps and slides well. Has no saw blade marking on the sides. Has some light scratches on the sides. Has some very light surface rust on the cast iron head.
Up for sale is rip fence with front & rear rails from a 10 Delta TS300 motorized table saw. They’re made for a table with a width of 20-3/8″ & a depth of 22-1/4″. The complete set will work for some other Delta saws with a table depth of 22-1/4, check the hole spacing on your saw to see if it’s compatible. The holes in the cast iron table must be centered 1 down from the top of the table. They show very little usage. There’re a few specks of rust due to storage in a damp locale. Fastenings included for the rails. One of the end caps is missing from the front fence rail.
These fit with the 2″ x 2″ front rail such as these rails I have for sale. This fence system is used on many models of 36-979 for example. For even more table saw parts!
Rockwell / Delta rip fence off a model 34-466 10 Unisaw. Very nice shape and works perfectly. It has some blade marks on the bottom edge as seen in the last two pictures and is missing it’s indicator pointer as shown.